Thanks Don.
I had changed nothing in the radio. Had been working just fine up to
this afternoon! Not just the filter, the radio is in AM mode even though
the mode says DATA.
Will go look at the filter set up!
Tom
On 10/6/2020 3:55 PM, Don Wilhelm wrote:
Tom,
You likely have the 6 (or 13) kHz filter enabled for both DATA and AM
modes. Use K3 Utility Filter Calibration to change it.
73,
Don W3FPR
On 10/6/2020 6:25 PM, Tom Azlin W7SUA wrote:
Hi.
My K3 seems to switch to AM around 5 MHz even though the display says
DATA. And the filter highlight on my P3 also switches to the AM width
around tuned freq.
Earlier I had tuned to 5 MHz WWV to do a sound card calibration and
switched mode to AM. Now was trying to test my fldigi FMT Modem
against 5 MHz WWV so switched to DATA. Still shows as if I am in AM mode.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
