Andy,
Thanks, but I'm trying to use KAT500-Remote Version 1.0.15.0 from
the Elecraft Web site, under "Logging, Control and Remote Software for
K-Line & KX-Line". This allows for hosting a KAT500 over the internet
for control by multiple clients. The actual commands sent to the tuner
are hidden by the software.
Thanks,
Gordon - N1MGO
On 10/10/2020 8:47 AM, Andy Durbin wrote:
"Someone on another group mentioned sending P; to the KPA500 would turn the amp on
provided to main power switch was on. Can you confirm that?"
The power on command is P not P;
From the programmer's reference -
"BootLoader Command Reference
The KPA500 uses single character commands when in boot mode. Boot mode is the
state the KPA500 is
in when the rear panel power switch is in the ON position, while the main
firmware is not running. This
mode is used for starting up the KPA500 or downloading fresh firmware.
Bootloader commands must be
sent upper-case only.
P Power On
The P command will cause the KPA500 to perform internal firmware checks, then
execute the main
firmware to power up the amplifier. This is the command to use to remotely
power up the KPA500. No
response is sent from the KPA500 after receiving this command."
Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
