See p.25 of the manual. Then p.30 set ATU HiSWR RETUNE to ON for 40m. GL - Steve WB6RSE
> On Oct 15, 2020, at 1:00 PM, Don Wilhelm <donw...@embarqmail.com> wrote: > > Pete, > > I would say re-tune after switching with the external antenna switch. > If you have tuned to one antenna (on a single port), and then change the load > slightly (by switching to the other antenna), a re-tune is necessary. > > 73, > Don W3FPR > > On 10/15/2020 3:17 PM, N4ZR wrote: >> I have two antennas for 40M, a Carolina Windom and a full-wave parasitic >> sloper, the latter fed through a 4:1 balun. The 1500's tuner handles both >> antennas nicely, and I have trained it on both of them, but when I switch >> from the Windom to the sloper (on an external antenna switch), the output >> power changes from ~1400 watts to nearly 1700, often triggering a high >> current fault. Any way around that? > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to wb6r...@mac.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
