Bill,
You might want to inspect the K60XV soldering carefully for bridges and
anything unsoldered.
When this fault condition occurs, what is the voltage on K60XV P1 pin 6.
If VRFDET becomes active during receive, the K2 may behave as you
describe because the firmware 'thinks' the K2 is transmitting. The fact
that you do not see it on the transverter bands further amplifies my
thoughts on the source of the problem being the VRFDET signal.
I cannot think of a component problem that would create your condition,
so that is why I asked you to review the soldering. Look at the
component placement too - make sure all the components are in the right
hole and not in a nearby via hole. Check D3 and D4 for proper orientation.
73,
Don W3FPR
On 11/28/2020 5:21 PM, Bill Coleman wrote:
A few weeks ago, I managed to cobble enough of the parts together to build a
K60XV. It came together great, and works both on 60m as well as a base for a
transverter.
I thought that would have been the happy end of the story, except I’ve had some
odd trouble with it installed. I saw this briefly the day after the SS CW
contest, and on the second day of the SS Phone contest. In each case, removing
the K60XV solved the problem and it did not recur.
Here’s what I’ve observed. After leaving the K2/100 turned on for several
hours, the rig is in receive mode, but the AGC is fully activated, with all ten
bars showing on the S-meter. The receiver audio is entirely blanked.
This condition is intermittent and random. It tends to last for several seconds
to many minutes. It happens on all bands at the same time EXCEPT it does NOT
happen on any TRN band that is configured (I have one configured for 50 MHz/28
MHz). This lead me to believe the K60XV was involved. During the SS Phone, I
removed the K60XV and replaced it with a Re-work eliminator and K2/100 and the
rig worked just fine for the next 10 hours.
During the last three days, I opened the K2 up and laid the KPA100 on the
workbench and left the K2 powered up with the K60XV installed. The problem
manifested itself within hours. I was able to run a few diagnostics.
The AGC activation happens in all all AGC modes, SLO, FAST and OFF. I was able
to get a scope probe on the emitter of Q12 on the Control board. When the
blanking occurs, I see a train of pulses around 2 mS apart - around 500 Hz.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
