On Jul 13, 2006, at 8:36 PM, W6NEK wrote:
Hi Michael,
I get the same type "Open Circuit" resistance readings as you and
my K2's worked just fine. All it means is the series resistance
between J1 Pins 1 - 7 is greater then 10 megs to ground which my
DMM reads as Open Circuit. If I were you, I would proceed with the
build. I think all is fine with your build so far.
73,
Frank - W6NEK
PS - I have built 11 K2's so far and they all acted the same as far
as high resistance readings are concerned.
Thanks, that is kind of what I was thinking. I saw the note that >50k
can read as open, but it threw me for a loop because up to that point
everything that said >50k had read something, but all of a sudden
some of the pins weren't doing that.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
