Doug,
Are you on 40 meters?
Did you measure the PLL Reference oscillator range (counter probe in
TP3)? What were the frequencies?
Any chance you replaced Q19 during the upgrade process? If so, where
did you get it?
73,
Don W3FPR
On 1/27/2021 12:22 PM, Douglas Hagerman via Elecraft wrote:
I am suffering from a similar problem in the midst of applying the various
upgrades. My BFO test numbers are good,
4917.13 kHz
4912.16 kHz
4.97 kHz range
but when I try the VCO linearization process, I see 11090 flash and then get
error 232. I have not checked the VFO against a reference frequency. I have
tried two different crystals and several different L31 values.
My planned next step is to assemble the RF probe and see if I can figure out
what is going on.
Doug, W0UHU.
From: M Bak <[email protected] <mailto:[email protected]>>
Issue. Unable to undertake VCO alignment.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
