Bob,
I believe you are ignoring the ALT button (hold of the left side of the
Mode button).
Why use a Macro? Set the K3 to SSB on the band of interest and change
the mode with the MODE button to select SSB the normal sideband for that
band, If it is not correct, hold the left side of the Mode button to
activate ALT. Go to the next band and do the same.
You can do the same thing for VFO B (or use the A>B button).
You can also do the same thing for DATA A and AFSK A modes if you use them.
When you switch to the bands after you have done the above, you should
be on the correct sideband - it will be remembered.
If you are entering the macro into a computer application, then ignore
my suggestion - I only operate "by the buttons".
73,
Don W3FPR
On 4/16/2021 6:18 PM, Bob Applegate wrote:
I’ve been trying to set up a macro to automatically choose the correct sideband
(USB/LSB) for the current band but have not found a way to do this. The MD
command allows specifying the mode, but there does not appear to be an option
to select the “proper” sideband mode for the current band. There is no method
to query the current frequency and do a conditional MD command.
Is there a way to do this?
BTW I am using the Programmer’s Reference Rev G5, 2/20/2019.
Thanks & 73
Bob - K2UT
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
