Hello Christian, all, According to the schematics, the encoder is directly connected to the MCU pins. I would assume, there is a connector issue in between? Can you check both lines between encoder and MCU, if possible?
Vy73 Harald DD0VS .-.-. --... ...-- -.. -.. ----- ...- ... > Am 24.04.2021 um 09:52 schrieb Christian Janssen DL1MGB <[email protected]>: > > > >> Am 24.04.2021 um 09:52 schrieb Christian Janssen DL1MGB: >> Hi Gernit, >> >> maybe I was a bit unclear. The RIT didn't work before I changed the encoder. >> And it still doesn't work after I replaced the encoder by a brand new one >> directly shipped from Elecraft. >> >> 73s Chris DL1MGB >> >> >> >>> Am 24.04.2021 um 09:39 schrieb G: >>> Hi Chris >>> I had the same issue with the filter shift pot. I mailed elecraft support >>> and they sent me a replacement part. Takes some effort to replace it but it >>> is doable. >>> 73 Gernit DF5RF >>> >>> -- >>> Diese Nachricht wurde von meinem Android Mobiltelefon mit GMX Mail gesendet. >>> Am 24.04.21, 07:38 schrieb Christian Janssen DL1MGB <[email protected]>: >>> >>> Hello, >>> >>> after doing some refurbishing (changing rotten connectors, cleaning,...) >>> I was curious if changing the RIT encoder will make the RIT work again. But >>> it doesn't. >>> >>> K3 #1532 >>> Firmware 5.67 >>> >>> I can press on the RIT and XIT button and it shows RIT and XIT in the >>> display, the green LED below the CLR goes on. But when I turn the RIT knob, >>> it stays at 0.00 and the frequency also doesn't change (also audibly). Also >>> when both RIT and XIT are OFF and CONFIG:VFO CRS is ON, then no coarse with >>> the RIT knob. >>> >>> Is there any hidden setting I missed? Or died just this RIT/XIT function >>> on the board? I also couldn't see any broken lines or parts around the RIT >>> encoder on the PCB. >>> >>> I am curious if there is easy help oout there. >>> >>> 73s Chris DL1MGB >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> <http://mailman.qth.net/mailman/listinfo/elecraft> >>> Help: http://mailman.qth.net/mmfaq.htm <http://mailman.qth.net/mmfaq.htm> >>> Post: mailto:[email protected] >>> >>> This list hosted by: http://www.qsl.net <http://www.qsl.net> >>> Please help support this email list: http://www.qsl.net/donate.html >>> <http://www.qsl.net/donate.html> >>> Message delivered to [email protected] >>> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
