Thanks Don, will check today. I also need to figure out which K2 need those small 3/8”x3/8” rubber spacers in-between the PC boards without taking the front panel off.
-73- Frank KG9H [email protected] > On Apr 25, 2021, at 9:27 AM, Don Wilhelm <[email protected]> wrote: > > Frank, > > Do you have the new encoder? I don't know which SN they were started. That > is the key to which knob you need. If the knob is off, lift the fiber > washers and check to see if there is a green tab in the hole to the right of > the encoder shaft. If the hole is empty, you have the new encoder. > Order the new knob from Elecraft - they no longer have the older knob. > With the new knob, you need 3 fiber washers stacked. > > 73, > Don W3FPR > > On 4/25/2021 9:00 AM, Frank Krozel wrote: >> I am looking for a tuning knob for a K2 SN 5630 >> If I recall there were two different sizes of shafts, this would be the >> second (maybe current) size. >> >> This is SN >> -73- Frank KG9H >> [email protected] >> >> >> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
