Stephen,
You should check very carefully the cores you used previously
to make sure they are correct. The cores you use MUST be
as indicated in the builder's manual.
de Joe, aa4nn'
----- Original Message -----
From: "Stephen Okolita" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, July 25, 2006 4:37 PM
Subject: [Elecraft] KAT100 RFC2 core.
So I'm building a KAT100 tuner and everything is going
along fine until I get to T1 and RFC2. According to
the manual T1 is supposed to be wound on a FT50-43
core (.5 in.) and RFC2 on an FT37-43 core (.37 in.).
Unfortunately all I have left in the kit are two .5
inch cores, one dark grey, the other painted red. So
I'm planning on winding T1 using the dark grey .5 in.
core. Do any of you experts out there think there
would be any harm in winding RFC2 on a slightly larger
core (.5 in. red)? Or should I go back to Elecraft
and wait for a replacement?
Your input is appreciated.
Stephen
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
