Jerry,
You will still want to remove the front panel to check the wiring of the
microphone configuration header.
It must be wired to match your chosen microphone.
Since you did not build that K2, you may not know how to get to the
Front Panel.
There are disassembly instructions at
https://www.qsl.net/wy3a/Replace_K2_Headphone_Jack.htm.
Of course, you likely do not have to replace the headphone jack, but the
disassembly instructions are the same.
73,
Don W3FPR
On 6/26/2021 8:39 AM, jerry wrote:
Just for yuks, I opened it up to see....what if the SSB adapter had
been installed,
and somebody pulled it out?
Sure enough, C167 was tacked messily to the top of the board.
According to the
schematic, you remove that when you install the SSB adapter.
That's good news. It means I just build the adapter, remove messily
tacked-on C167,
plug the adapter in, and align. Don't have to take the front panel
apart.
...or so I hope.
- Jerry KF6VB
On 2021-06-25 15:24, Don Wilhelm wrote:
Many filters constructed using the newer crystals do not have that
tilt, especially at narrow filter widths.
Wide filter widths do have both tilt and passband ripple.
Having aligned almost 2000 K2s, I can say this with certainty.
73,
Don W3FPR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
