Paul,
I have not looked at the KXSER cable in the amp manual, but I am
assuming it is the same as that shown in the back of the XG3 manual.
You can download that manual to check - I know that one works.
I run only Windows - tried Linux some time ago and while it worked OK
for an isolated machine, I could not get a good way to link it to my
Windows network (important because I use a single fileserver on the
network) - Tried several SAMBA configurations, but was not successful.
That was the time Windows 98 ran out of support, and I ended up buying
enough Win 7 installations for all the computers on my network.
Recently I have been buying computers pre-loaded with Win 10 Pro.
73,
Don W3FPR
On 6/30/2021 5:09 PM, Paul Jewell wrote:
Hi Don,
I should have given more details -
* Running linux
* ftdi drivers are all installed, and the port of /dev/ttyUSB0 is
installed
* The Tx lights are flashing on the ftdi adaptor, suggesting it is
working as expected. I may plug another device in to see if I can
confirm this (perhaps a null modem of some sort)
* I did try to swap the RXD and TXD, but this was on a different ftdi
adaptor - I will try again with this current ftdi device. I will
also try a different PC when I go in the house (this will give me a
chance to try Windows instead as well).
Thanks for the comments!
73,
Paul - MW7PAJ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
