Good morning all,
Thanks to help from Jon (ea2sn), this problem is resolved. Elecraft use
inverted signals for the RS232 connection, so I re-configured the ftdi
device using the ft_prog utility (under windows), and then the
connection worked as expected.
Thanks for all your comments!
Best regards,
Paul
On 30/06/2021 21:14, Paul Jewell wrote:
Good evening,
I am trying to find a wiring layout for the kxusb cable. I have the
wiring diagram for the kxser cable (from the amp manual), and have
tried using an FTDI adaptor with this layout. Unfortunately the
software reports that the KX3 is not responding.
Have any of you gone down this route, and achieved a successful
outcome? I have ordered a new cable, but it won't be here for a few
days, and this should be a solvable problem with the spares I have in
my shack!
Many thanks!
Paul
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
