Hi folks, My PX3 is up and running! The manual was a delight to follow, and everything went together swimmingly. Thanks for all the tips -- I had everything small neatly laid out in an egg carton, and assembling this was probably the most peaceful hour of my day.
Here is a lousy phone picture of the finished product: https://photos.app.goo.gl/NsXTLNo2zZPcuM4p9 One question: I performed the sideband nulling procedure, and found that my ideal phase values were similar to the factory ones, but that my ideal amplitude values were consistently about 25 lower than the factory ones. Is this indicative of an issue with my equipment, build, or calibration? Or is it within the expected range of calibration values? Thanks and 73, Julie On Fri, Oct 1, 2021, 11:53 Geert Jan de Groot <[email protected]> wrote: > > > Just follow the instructions.? You will need a #1 Phillips screwdriver. > > Are you sure that's Phillips? I use Pozidriv (PZ0) for Elecraft screws > and find that is a much better fit. > > (Either will work, but if you have one of those 100+ screw sets and have > the choice - consider PZ over PH screwdrivers for electronics) > > Yours for screws that are not stripped, > > Geert Jan > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
