I did check just before I sent my note. The new K-Pod F/W works the same as 1.09. At each setting in the K3S (was the same as the K3 I had before), the K-Pod tuning rate is one-half of that in the radio.
I bought the K3 in 2009 and the K3S in 2017, and that never changed. 73, Jim N7US From: Bob Wilson, N6TV <[email protected]> Sent: Friday, October 29, 2021 18:28 To: Jim McDonald <[email protected]>; Elecraft Reflector <[email protected]> Subject: Re: [Elecraft] Elecraft K-Pod manual updated -- now covers use with the K4 On Fri, Oct 29, 2021 at 4:19 PM Jim McDonald <[email protected]<mailto:[email protected]>> wrote: My K-Pod tune at half the rate of the K3S at all three VFO CTS settings. Check again, because that does not match my experience if your K-POD firmware is at 1.09 (can't test now, sold both K3s). If CONFIG:VFO CTS is set to 100 (or 200?), I'm pretty sure the K-POD knob tunes at the same rate as the VFO A knob. I don't think a power cycle is required. If Elecraft could do it, I'd like for the K3/K3S F/W to provide the option for the K-Pod to tune at the same rate. Yes, we asked for that years ago, but it never happened, and I don't think it will ever happen. There's just no room left in the K3's limited memory to add such complex code now. Consider upgrading from the K3 to a K4. K-POD plugs straight in via USB cable and works perfectly. 73, Bob, N6TV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
