Hmmm ... and here I thought I was way too old to learn new things.
1. There's a K-Pod utility
2. There's an update for K-Pod firmware
3. My K-Pod runs with just the flat cable inserted and no wall wart needed
4. To get the K-Pod utility to work, you have to do some finger
gymnastics on F1/F4
5. The new FW rev really does change the encoder rate
All I'm missing now is, "Do I like my old rate [1/2 the VFO A rate] or
the 1:1 rate?" I'll try the new 1:1 for awhile. Odds are very high
I'll get used to it right away and not notice the difference.
73,
Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County
Jim McDonald wrote on 10/31/2021 4:05 PM:
From: Bob Wilson, N6TV <[email protected]>
Sent: Sunday, October 31, 2021 17:52
To: Jim McDonald <[email protected]>
Cc: [email protected]; Elecraft Reflector <[email protected]>
Subject: Re: [Elecraft] Elecraft K-Pod manual updated -- now covers use with
the K4
Did you try upgrading the K-POD firmware to 1.12 to use these new features?
1.12 10/20/2021
Holding down F4 on power up selects encoder 1:1 rate.
Holding down F5 on power up selects 1:0.5 rate.
73,
Bob, N6TV
--
--
This email has been checked for viruses by AVG.
https://www.avg.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
