Chuck Gehring wrote:-
"The closest I came to success was seeing a tiny blip of undecipherable
data stream on the hyper terminal window during the K2 port test."
I am in the same position except I measured it with a multimeter set to
the AC millivolts range (on Gary Surrency's advice) and the software
responds with a one time change of frequency and mode (N3FJP ACLOG). My
question is what in the K2 generates the continuous data stream?
My story is that I think that in a nearby lightning strike, my USB/RS232
adapter was fried. I also found that my Adapter chip on the I/O board
needed replacing. In debugging this condition I destroyed the MCU
(grugh).That's now replaced and I'm at this one shot condition. I
replaced my damaged adapter, that was working, with the same make (from
Buxcomm). That works to extent that it passes on the one shot data. Any
ideas?
73, Dave Lear
NE5DL
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
