Snowy,
It sounds as though you have the proper BFO crystals installed at X3 and X4.
Do check the values of C173 and C174 first
Then check L33 to make certain it is well soldered and the leads are
attached to the 1/8 watt resistor leads.
Check D37 and D38 to be certain they are oriented properly and well
soldered.
Lastly, lift one side of L33 (and its resistor and remove the rubber pad
- check the resistance of the pad itself - there were a few (a while
ago) that were found to be conductive causing problems such as yours.
Since you did not state the vintage (or serial number of the K2), do
that check if those items above do not correct the problem.
While you have the rubber pad out, make certain that about 1/2 of the
stem has been cut away. That is to allow the 1/8 watt resistor to be
pushed down into the center of L33 to tighten the leads and hold L33
securely in place.
If the rubber pad under L33 is found to be conductive, get a new one
from Elecraft, or -- If you have an unassembled KAT2, you will find
several of the rubber bumpers in that kit - a conductive one will work
fine in the KAT2, but not in the BFO circuit.
73,
Don W3FPR
On 12/16/2021 5:35 PM, ROLAND HOWELL via Elecraft wrote:
having repaired my PLL problem with a great deal of help and advice
from Dave at tech support, Elecraft i moved onto the next set of tests
which was the bfo frequencies, on selecting CAL, Counter i get a
reading of 4.9136, on pressing either the band up or down all i get is
zero's.
Fitted crystals are 4.91s in X3 and X4 positions
Have checked all the details in the trouble shooting paragraph, i can
find no fault with any of the components, all values and positions are
correct.
I have to add that this was purchased as a non-runner.
Any advice appreciated
Snowy,G0HZE
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to d...@w3fpr.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com