Sounds like you should do the low-level power calibration using the K3 Utility. For now, you can increase the maximum, up to 1.5 mW, and presumably get the desired output.
Gary NA6O > Using the Config Menu, I have set the drive level at the maximum for the > transverter at 1 MW. However, when I check the drive from the front panel > PWR knob it reads 0.8MW and I cannot adjust it any higher with the knob. > Nothing I do seems to change the the PWR knob drive level. I am running SSB > on 432.095. > > Any suggestions would be most appreciated. > > Tnx es 73, > > NS4V ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
