The only reason I can think of why this might apply is if the grounding
of the bottom cover was poor. Whilst it certainly can be poor, because
of paint not having been properly masked around the mounting blocks, and
I recommend cleaning all paint off, around them, I'd be surprised if
enough of the induced currents, in the bottom panel, flowed through
these points to make a difference.
--
David Woolley
Owner K2 06123
On 30/07/2022 16:25, Wolfgang wrote:
in a german QRP forum I found this hint from Peter, DL2FI (SK).
In any case, the PLL calibration must be redone whenever the bottom
cover of the K2 has been opened.
Therefore my question, of it is really so that "CAL-PLL" must be done
again after *each opening* of the lower housing cover?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
