I normally run a K3S, a KPA500, and a KAT500, and the combination is dynamite.
Recently, I bought an IC-7300 as a backup radio, and I’ve been busy integrating it into my station in such way that makes it quick and easy to switch from the K3S to the 7300. Related to that integration I have a question about powering the KAT500. Normally, the KAT500 takes its DC power from the K3S. The easiest way to power the KAT500 when using it with the 7300 is the have to K3S powered up but not connected to any of the antennas. All of its other radio-to-tuner cables remain connected as usual. Is there any way this arrangement can hurt either radio, especially the K3S? It’s already been back to the factory once. If that’s safe for the radios, my IC-7300/KAT500 setup tuner power options are: Continue powering the tuner from the K3S. —— My choice. Temporarily unplug the K3S DC power cable from the KAT500 and plug in a separate 12-volt supply. This semi-acrobatic feat, performed by touch alone, must be done every time I switch either way. I’d prefer to let the K3S power the tuner, but is that safe? Cheers! Richard Kunc W4KBX [email protected] <mailto:[email protected]> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
