It worked. Thanks. On Sat, Apr 29, 2023, 2:02 PM W3FPR <[email protected]> wrote:
> Rich, > > Try this -- bend the pins in just a little bit and try it that way. You > don't have to bend them very much and they will straighten out when you > get the job done. > > 73, > Don W3FPR > > On 4/25/2023 10:49 PM, Richard Hill wrote: > > I'm installing a new but old KXV3A board into the J66 block. The > > instructions say the pins should just clear the top of J66 when the BNC > > connectors are up against the top of the back panel opening. I am not > > seeing a way to orient the board such that the pins clear the block. The > > pins seem to be just a bit too long. This board was purchased back in > > 2011. It is revision A. > > > > I'll call Elecraft in the morning, but thought I'd try the brain trust > here > > to see if I can complete this project tonight. No hurry, grin. It feels > > like I should be able to do this, but I'm just not seeing it. I'm > tempted > > to cut the ends of the pins about 1 mm, but will wait till I talk to > > Elecraft. I have an updated board on order, but thought I'd just put the > > old board in and see if I can get my P3 running. > > > > Thanks for any thoughts! > > > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
