I've always thought it was putting out the 15 watts, or 12 as the case may be, since it has all the firmware updates, but looking at the dummy load, it's at 10 watts, if that, with the PO control at 15 watts on all the bands! Using 13.8V indicated, at 6A Not sure whats going on but any info appreciated. Thanks, Ken, W2GIW
MCU 2.38 / DSP 1.37, 1-3-2015 * POWER OUT NOW 15 WATTS MAX, 80-20 M: On 80-20 meters, the PWR control can now be set as high as 15 W (max is still 12 W on other bands). Supply voltage must be over 12.8 V on key-down as indicated by the KX3’s voltage display (tap DISP, rotate VFO B). Note: The KX3 will automatically reduce power as required if current, SWR, or temperature is excessive, or if supply voltage is too low. If a band other than 80-20 m is selected, power output will be cut back to 12 W max. It must then be manually set above 12 W after switching to 80-20 m. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
