I just finished installing the KDPS2 boards and they check out OK. I also have
the KAT2 installed and it "was" working.
I was going to operate today for the first time but when pressing TUNE, I'm
not getting any power out. I have an external watt meter too. When I press
TUNE, I see Atu on the right side of the LCD then it quickly flashes to 1.0-1
on the left side , then displays Lo P. I've changed bands and frequency's up &
down but do not here the relays in the antenna tuner "clicking" as before. I
went through the various relays through the MENU and I can here each individual
relay "click" just as I did when first testing the KAT2 option. Nothing on CW
or SSB. I switched to ANT2 which is my Elecraft Dummy Load with the same thing
happening so it isn't a problem with the antenna.
The KAT2 manual says that when this happens to increase the power which I did
in steps up to 15 watts with no change. ???????? Am I missing a setting or
does the KDSP2 board have something to do with this. I believe I installed the
top cover correctly and have all the wires connected after installing the DSP
boards.
Any suggestions ?
THANKS.........Gary WD8ICX
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
