Andrew,
If you only see the problem when the KPA100 is installed on the base K2,
look at the wiring for the VRFDET line from the KPA100 to the K2.
Broken wire or a pin not making proper contact with the K2 connector.
This is a ribbon cable, but check for bad wires anyway - check at both
ends of the cable.
73,Don W3FPR
On 7/27/2026 5:38 PM, Andrew Lenton wrote:
See comments on brackets
KR
( Only see the problem after I put the PA back on the K2)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
