Hi Cathy,
If you are only using XV144 for RX mode, you don't have to do any
modification. Even you use XV144 for any non K2 transceiver, the
connection is also simple. The XV144 operation manual listed out all the
connection possibilities.
My K2 does not have any of the KIO2 or K60XV, the connection is based on
the diagram related to non K2 transceiver. The operation manual gives very
detail connection method.
I do not think any modification for your Uniden is required.
73
Johnny Siu VR2XMC
From: Cathy James <[EMAIL PROTECTED]>
To: [email protected]
Subject: [Elecraft] XV144 paired with Uniden HR-2600?
Date: Thu, 19 Oct 2006 19:40:34 -0500
Folks,
I am interested in building the XV144 transverter. However, I do not
want to tie up the K2 as the IF. Instead, I have a Uniden HR-2600
(unmodified) lying around that I'd like to use for the IF/tuner/etc.
Has anyone out there used the 2600 or 2510 as the IF for the XV144?
How difficult is it to do this? Reading thru the XV144 manual with regard
to separate TX/RX cables, PTT cables to trigger the XV, blah blah, makes me
a bit nervous. Am I going to have to modify the Uniden?
Any suggestions would be appreciated.
Cathy
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_________________________________________________________________
享用世界上最大的电子邮件系统― MSN Hotmail。 http://www.hotmail.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
