I am progressing on my K2 project, I just finished the steps on page
57 that had me solder several components to the bottom side of the
RF board. My problem is getting my cutters into some of the tight
places on the top of the board. I thought the hard part was over when
I finished soldering without causing heat damage to near by
components but I am finding it nearly impossible to trim the leads
now. I have the recommended angle cutting tool but I still can't get
down to board level with them to cut them anywhere near flush.
Any ideas.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
