I found, to do neat Bottom devices - I would pre-bend device leads ahead of time. And I would then trim devices leads, so that they extended just enough up and above the PCB board's top surface before I installed device. Then carefully hold the device against the PCB board's bottom surface - and then slightly and gently, bend each lead - in order to keep device in place. Then sold from board's top!
After a while, I got pretty good at allowing very short device leads, from poking thru on top! Fred FL __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
