Good point, Gregg! I have the FL1 BFO frequency on my K2 set for optimum transmit audio (using the OPT1 filter of course). For my taste the receive audio is a bit "bright" on many signals (not enough low frequency response) so I have the FL2 position BFO frequency set up to shift the passband for a more pleasing response.
Since the K2 uses only the OPT1/FL1 settings for transmit, setting up the other filter positions for different audio characteristics has no effect on the transmit audio, even if one is selected for receive when I transmit. Ron AC7AC -----Original Message----- Just remember also that the OP1 filter for SSB receive is also used on transmit. I found that my Heil Pro headset was too muddy so I tailored the OP1 filter for best response and have got fantastic audio reports on my K2. Gregg R. Lengling, W9DHI, Retired,Again K2/100 SN 3075 http://www.milwaukeehdtv.org http://forums.ham-radio.ch/ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
