(I sent this earlier and it didn't seem to get posted. If it is a
duplicate, sorry for the bandwidth.)
While I am waiting for my XG2 to arrive I would like to discuss the
problem that I am experiencing. On 20M my K1 is outputting on 20.17 mhz
with gravelly tone, the is VCO set at14.00 mhz. All other bands are on
frequency (+- a couple of K) with pure tone. Also with a 100' wire
antenna, I am receiving CW just fine on 15M, 30M and 40M. On 20M just
hiss with an occasional birdy. Output on all bands including 20M is 5W.
All voltage and resistance checks are good. I have checked my soldering
and even re-soldered X2 with no help. The only other components
exclusive to 20M is C3, C4, CC, and CD which all adjust OK during the
band alignments. I am suspicious that X2 is off frequency but I want to
go through the receiver and VFO signal tracing (come on XG2!) and
transmitter tracing before I start replacing anything.
Any ideas would be greatly appreciated.
73
Larry
KB5DXY
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
