Hi,
I have the same pb on 160m only. Below 6W out is OK, but when trying higher
power than 6W then ramp up the current and HiCur warning comes althought the
SWR indicated after tunning by ATU is 1.2...K2 not K2/100.
73, Petr OK1RP
------------ Původní zpráva ------------
Od: Fred Jensen <[EMAIL PROTECTED]>
Předmět: Re: [Elecraft] HI CUR and 160 Meters
Datum: 22.11.2006 23:55:53
----------------------------------------
John Huffman wrote:
> The situation is that at 12W out the K2 (KSB2, KNB2, KDSP2, K106RX,
> KIO2) draws 2.5 amps. With power set at anything above that, it exceeds
> 4.5 amps and I get a Hi CUR warning (limit set at 4.5 amps).
Parasitic? I had that problem on 40m with the KPA100 and KAT100. Ran
OK at lower power (~15W - 25W) but went berserk at higher power. It
even blew the 12V DC line fuse once. Gary fixed it but I'm not sure
what he did.
Fred K6DGW
Auburn CA CM98lw
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
Petr Ouředník
00420608230010 (private)
[EMAIL PROTECTED]
http://ok1rp.blog.cz (Hamradio)
http://topband.blog.cz (160m)
www.qsl.net/ok1rp
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
