Different problem when he doesn't have a KPA100 though.
Tom
At 04:53 PM 11/22/2006, Fred Jensen wrote:
John Huffman wrote:
The situation is that at 12W out the K2 (KSB2, KNB2, KDSP2, K106RX,
KIO2) draws 2.5 amps. With power set at anything above that, it
exceeds 4.5 amps and I get a Hi CUR warning (limit set at 4.5 amps).
Parasitic? I had that problem on 40m with the KPA100 and
KAT100. Ran OK at lower power (~15W - 25W) but went berserk at
higher power. It even blew the 12V DC line fuse once. Gary fixed
it but I'm not sure what he did.
Fred K6DGW
Auburn CA CM98lw
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
