Make sure the switch on the upper right (as you look at the front of the K2) of the control board is set for volts.
Mark, KJ7BS Glendale, AZ -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Thursday, November 23, 2006 10:10 PM To: [email protected] Subject: [Elecraft] K2 Problem Hi Well, I have a problem with my K2, but don't know if it is worth trouble shooting. In the first initial test the VFO works fine on all the bands. All the relays click when checking them as per the manual. When tapping the display button it changes to the volt meter, but it doesn't read voltages. It always stays on all zeros when checking the voltage on pin one of U1. Even tried to check the voltage of a flashlight battery by running a lead from the ground loop on the RF board to the negative end of the battery, and the lead from P1 to the positive end of the battery, got nothing. U1 pin one does have 6 volts on it bacause I checked it with my DMM. Since the voltmeter doesn't work, that means the RF probe won't work either, I guess. I checked the continuity of the lead from P1 by running a resistance check from the bottom of the RF board to the end of the test lead. Haven't checked the manual yet for trouble shooting it, but if anyone has any suggestions on where to start looking, I would appreciate it. Thanks Scott N5SM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
