I'm building a Rev D KPA100. During the final resistance checks (p.43) I got 11.5 ohms for both Q1 base and Q2 base. The manual 11-16 ohms for Q1 and 12-16 ohms for Q2. So Q1 is OK but Q2 is out of spec? This resistance table was changed by the eratta. Before that it said 12-16 for both transistors. I'm thinking this is a documentation error and it should say 11-16 for both but before I apply power I figured I should check. - Keith N1AS - - K2 5411.ssb - _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
