I should have said "..so I could store 28.025 as CW on VFO-A and 28.500 as USB on VFO-B"
----- Original Message ----- From: "Tom Althoff" <[EMAIL PROTECTED]> To: "Elecraft" <elecraft@mailman.qth.net> Sent: Saturday, December 09, 2006 7:37 AM Subject: [Elecraft] K2 Firmware request I'm sure this has been asked before but I sure would like to have VFO-B have its own 'mode' register so I could store 28.025 as CW and 28.500 as USB. Is that possible or is there no room at the inn? Also, does the RS-232 command set allow querying which VFO is active? I use B for SSB during contests and A for CW. Tom K2TA _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com