Kathy, I am building a K1 here too and just stumbled across this same problem. It seems like the silk-screen does not stick on the new ROHS compliant boards (or something like that - the flats used to be in the silkscreen).
Put the flat side toward the back of the K1 board - if you have any doubts obaut orientation and need a 'picture' there is the component placement drawing in the back of the manual. 73, Don W3FPR > -----Original Message----- > > I am unclear on the correct orientation of C13 and C20. The directions > state "this [flattened] side must be oriented towards the flattened side > of the component outline." Unfortunately, the component outlines on my > RF board are symmetrical as far as I can see, with no sign of > flattening. Perhaps the through-hole is completely covering up the flat > part of the outline. > > Could someone post the correct orientation without reference to the > outline, e.g. "the flat side of C13 should point toward component XYZ"? > > Thanks, > > Cathy > N5WVR > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.15.15/580 - Release Date: 12/8/2006 12:53 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
