I assume you mean the rtc (real-time clock). It is on (or at least starts out that way, with power on). However, after some time of operation, I get "not inst." The DSP filters work fine-- I just can't call them up in the menu to edit them or make changes without doing the power on/off.
So far have not heard from Elecraft support on this. 73, Chuck NI0C ----- Original Message ----- From: "Jean-François Ménard" <[EMAIL PROTECTED]> To: "Chuck Guenther" <[EMAIL PROTECTED]>; <[email protected]> Sent: Wednesday, December 13, 2006 8:16 AM Subject: Re : [Elecraft] KDSP2 questions Just switch ON clock in SECondary K2 menu ----- Message initial ---- De : Chuck Guenther <[EMAIL PROTECTED]> À : [email protected] Envoyé le : mercredi 13 décembre 2006, 08 h 22 min 38 s Objet : [Elecraft] KDSP2 questions 2.) Referring to the KDSP2 Manual, page 38, troubleshooting: The middle of the page gives the following symptom (which I experience frequently): "AFIL works but I can't access DSP or clock menus when I press Display" The manual goes on to suggest turning the K2 off then back on. This works for me, but is there a better fix for this? The manual also says to "let us know" if this happens frequently. I have e-mailed Elecraft support regarding this. __________________________________________________ Do You Yahoo!? En finir avec le spam? Yahoo! Courriel vous offre la meilleure protection possible contre les messages non nollicités http://mail.yahoo.ca Yahoo! Courriel _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
