Don and Lyle, It's working! I removed the KDSP2 module and heated up a couple of dozen solder connections, especially at the connoectors. While I was at it I built the KNB2 module and installed it. I used the audio filter un-module from Rework Eliminators to replace the KDSP2 module while I checked out the KNB2. Then I reinstalled the KDSP2 and now have solid communications with it.
Thanks to both of you for your assistance. 73, Chuck NI0C ----- Original Message ----- From: "Don Wilhelm" <[EMAIL PROTECTED]> To: "Chuck Guenther" <[EMAIL PROTECTED]> Cc: <[email protected]> Sent: Wednesday, December 13, 2006 9:11 PM Subject: RE: [Elecraft] KDSP2 questions > Chuck, > > If you get the "not inst" message it means that the KDSP2 is not being > recognized. > The fact that it is intermittent indicates that there is a bad solder > connection somewhere. > You might try re-flowing the solder on the KDSP2 board. > > 73, > Don W3FPR > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
