Kieth, The gap is a little more than 1/16 inch and less than 1/8 inch. If you solder the pins so there is just a bit of the square portion sticking beyond the ATU board surface that should be close enough.
73, Don W3FPR > -----Original Message----- > > I know it's bad form to reply to your own message, but I think I > just found my own answer in the Errata sheet. It sounds like > that gap is ok to be there.... > > So now the question is, how big should the gap be so that I can > get it back? > > 73 de Keith KB3ILS > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.15.26/597 - Release Date: 12/21/2006 6:45 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
