On Thursday 08 February 2007 20:44, Michel wrote: > Little tool for the winding of toroids > > During the building of my K2 I was facing some troubles to wind toroids > which had sharp edges grinding the enamel of the copper wire. > I would like to suggest you following trick which I used with success. > See link below.
All you need do is to take off the sharp edges with a countersink bit. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com