Check your display installation and the display driver (the big chip on
the back) installation. Make sure there were no bent pins when you
pushed that thing in. I know I was sweating bullets during that. I
assume all your other resistance checks on that chip were fine? Did you
check them on the pin of the chip, or on the associated pin on the back
of the board?
David Wilburn
[EMAIL PROTECTED]
Matthew D. Pitts wrote:
Gentlemen,
I'm at the first alignment stage and I've run into a problem. I was able
to get the INFO 201 message upon first power-up, but I haven't gotten
anything to display other than ELE on subsequent power-ups. Also, I have
to look at the display at an angle to see that. Any ideas on what to
look for? I can't proceed with the K2 itself until I finish these tests.
I guess it's time to build the KIO2, KSB2 and K160RX so they're ready to
install when I get the rest of it done.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com