Good Afternoon everyone, An update on my issue. I removed R19 from the circuit, measured the voltage at RP2 pin 2 and found 0 vdc. I checked the frequency at TP3 and still find 12.602 MHz. Now I know the problem doesn't lie in the thermistor board as the problem is still there even with the thermistor board removed. Although there is no obvious cold solder joints, I'm going to reflow the joints as the only commment I've gotten from anyone that has looked at the board is that I may have been a little skimpy solder. Cheers Terry VA6MAC
************************************************************************ This e-mail message is intended only for the person(s) named above and may contain confidential or privileged information. If you are not the person named or have not been authorized by them to access their mail, please notify the sender immediately and delete this e-mail and any attachments without reading, saving, or forwarding. ************************************************************************ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
