Certainly, a zero ohm reading is an indication that pin 4 or the circuit trace or relay K1 pins 3 or 6 are shorted to ground somewhere. It could also be on relay K2 depending on the state of the relays or could be caused by a shorted crystal, or excess solder that wiched up onto the crystal lead and shorted it to the case.
Check the soldering, especially for excess solder. Just enough to fill the plated thru hole is sufficient, and if there is much more than that, it can create solder bridges and short one circuit to another. Name and call please? 73, Don W3FPR > -----Original Message----- > > I have just finished building the 4 band filter board ( KFL1-4) > for the K1. I have 3 incorrect resistance checks that I cannot > resolve. I'll do these one at a time for clarity's sake. > The first is P1, pin 3 to pin 4. Desired reading is greater > than 100k. I'm getting zero. Any suggestions ? > Al > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.446 / Virus Database: 268.18.8/717 - Release Date: > 3/10/2007 2:25 PM > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.446 / Virus Database: 268.18.8/717 - Release Date: 3/10/2007 2:25 PM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
