To the best of my ability (e.g. memory) I put the shorter flat side
along the flat side on the silk screen, and the long flat side against
the long rounded side of the silk screen. I just finished my rig over
the weekend and aligned it without issue.
David Wilburn
[EMAIL PROTECTED]
K4DGW
K2 #5982
eKotz wrote:
Folks,
I have successfully reached my K2 Assembly, Part III, pg. 65, trimmer
installation step. The red marked trimmers were no problem identifying
the orientation. It looks like the 30 pF trimmers are different than
were in the older kits and there is my difficulty: The 30pF trimmer caps
(C32, C34, C44 & C46) have two flat sides... a large flat and an
opposing small flat and my question is... which is the correct flat for
proper orientation? --I did not find this in the archive... I may not
be phrasing my search properly.--
Thanks,
Ed - AD7GR
K2 6050
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
