I had the same problem, turned out to be a bad solder joint on one of the
wires going from the board to the encoder.
Jim - KA2RVO
K2 #5919
From: [EMAIL PROTECTED]
To: [email protected]
Subject: [Elecraft] K2 Optical Encoder Test Problem
Date: Sat, 14 Apr 2007 18:58:02 +0000
Just started the the alignment & test Part 1 on my K2 (Rev. f) page 42.
Everything went well, no smoke or error codes, until I got to the Optical
Encoder Test step2. It says to turn VFO knob in both directions and verify
that displayed freq. changes accordingly. The only change I see is the
right most digit, and it only changes from 7100.00 to 7100.01. Obviously
not much movement. Have not seen this particular problem posted so I'm in
the dark as to know how to fix it other than check my previous work. Any
help would be appreciated.
Guy Bridge
N7BIR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
