I'm trying to determine whither I have a problem or not. I measured my supply voltage at 13.22 V.
My voltage check at P1 pin 16 shows a voltage of 12.98 V (Supply - 0.24V). If I calculate the predicted voltage it would be 12.92 V (Supply - 0.3V). I'm off by 0.06 V. Is this a problem that needs attention? What should I look for? I've looked for cold solder joints and found none, but old vision may not be the best. I've also taken some digital photos to double check. The only problem I found was what seemed to be a bunch of resin in one through-hole for C8 (first noticed when I tried to install C8). I desoldered that connection and cleaned out the hole and resoldered. It seems fine and not relevant to a pin 16 problem. No change in pin 16 voltage. The good news is that I passed the smoke test! This is my second kit. First was a RockMite. Thanks for any help. NU6T Rich _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
