Richard,
You may be cutting the straws too thin.
What that means is simply that your series diode has a voltage drop of
0.24 volts rather than the nominal 0.3 volts - that is 'goodness' - a
low voltage drop across the protective diode is to be desired.
73,
Don W3FPR
Richard Hill wrote:
I'm trying to determine whither I have a problem or not. I measured my
supply voltage at 13.22 V.
My voltage check at P1 pin 16 shows a voltage of 12.98 V (Supply - 0.24V).
If I calculate the predicted voltage it would be 12.92 V (Supply - 0.3V).
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
