I have been using TruValue twin lead at $14/100 feet for the past 4
years on both my G5RV and my 40 meter loop. Works just fine. Best
bargain around. Since I only need 40 feet on either antenna, if it goes
bad, I just use the other half of what is left with some to spare.
Jozef WB2MIC
PS. The antenna wire is leftover electric fence wire now over 22 years
old. Cost per antenna per year is quite low. :)
Robert Tellefsen wrote:
Thom
There are various grades of 300 ohm twinlead.
Some are very cheap and have pretty skimpy
conductors. Some are good quality. There is/was
at least one version that was suitable for transmitting
(power level not stated that I can recall). If you
have some of the good quality stuff, you can probably
do 100w just fine. I'd watch out for the skimpy stuff,
though.
Good luck and 73
Bob N6WG
----- Original Message -----
From: "Thom LaCosta" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, August 14, 2007 4:26 AM
Subject: [Elecraft] Twin Lead feedline
It's been years since I melted 300 ohm twin lead...
Can I use it for a 44 foot each side of center doublet at 100 watts out?
I
can't find any other open wire feedline locally, and I need to get
something up
in the air....I keep on walking into the slinky that runs down my hallway.
I'm thinking at 5 watts it will pass...just not sure what will happen at
100
watts.
Thanks
73 k3hrn
Thom,EIEIO
Email, Internet, Electronic Information Officer
www.baltimorehon.com/ Home of the Baltimore Lexicon
www.tlchost.net/hosting/ Web Hosting as low as 3.49/month
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
