Hello again,
thanks for "Phase noise" data and discussion.
What I am now looking for are some other informations important for
using K3 as I/F for serious VHF/UHF/SHF contesting/DXing.
First question is about display readout in "transvertor" mode - is there
possible some offset - for example 144 000.00 is on 28 001.15 ?
Second question - maybe more general - is about TX possibilities outside
standard HAM Bands. For example if my 2m transvertor is built for 26MHz
(26MHz/144MHz instead of stadard 28/144). The reason is that the rest of
line (transvertors from 1296MHz up) are built to use I/F 145, 146 and
147MHz - normally when 144 is on 28 there is no way to use 31MHz on
standard gears, but with some mods is possible to use any lower frq. up
to 30MHz.
Thanks for any info or link to such info,
73!
Lexa, ok1dst
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
