Concerning TX/RX out of ham bands:
Maybe there is some way thanks to firmware - allow general coverage ONLY
in transvertor mode.
Maybe some wish-list is there...
About offset - if it is the same as on K2 it is +-9,99kHz so sometimes
it is enough. Maybe it is not the same as on K2, who knows...
73!
Lexa, ok1dst
[EMAIL PROTECTED] napsal(a):
Ahoj Lexa,
I do not believe that there is many such requests for having ...
I agree with you that most standard rigs will not go above 30MHz and often do
better on 14MHz or 21MHz than they do on 28MHz. I would hope that the K3 does
show major differences in its performance from band to band. I do think that
using low VHF for the IF could make good sense, assuming of course that the IF
transceiver does a good job at these frequencies.
are after some mods able to go from 1 to 30MHz ...
If I remember correctly, Wayne has written in the past that the K3 will not
transmit in the CB range and that this blocked by the firmware. The firmware
will not be released, i.e. user firmware modifications are not possible. At
least not without a lot of reverse engineering. Also I believe that Wayne also
wrote that Elecraft will compile different versions of the firmware with feature
adjustments depending on the local laws of where the K3 is going to be used.
OperationalManual to study - not found on Elecraft Web ? ...
I am sure that the manual will be downloadable soon - a fortnight or so?
vy 73 de toby
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
